Low EMI modulation structure
The MAX9700 / MAX9712 use a unique modulation structure to provide Class AB efficiency with Class D efficiency and take up very little board space. The MAX9712 can provide 500mW of power for 8W loads, and the MAX9700 can provide up to 1.2W of power for 8W loads. There are two comparators inside the amplifier to monitor its input and compare the complementary input voltage with the sawtooth wave. When the amplitude of the sawtooth wave input exceeds the corresponding comparator input voltage, the comparator output is inverted. When the input voltage increases or decreases, the duration of the comparator output pulse of the first transition increases, and the duration of the output pulse after the other comparator transitions is tON. For a certain input signal level, the comparator output is a pulse width modulated square wave signal, the period is determined by the frequency of the sawtooth wave oscillator, the PWM signal controls the H-bridge driver, turns on or off a pair of MOSFETs in opposite states, making the speaker The net voltage at both ends (VOUT +-VOUT-) changes with the input signal, effectively collecting audio input. The dynamic range of the amplifier is determined by the amplitude of the noise and the amplitude of the sawtooth signal.
Operating mode
The MAX9700 / MAX9712 have two operating modes: fixed frequency modulation (FFM) mode and spread spectrum modulation (SSM) mode. In FFM mode, the frequency can be selected through the SYNC pin. When SYNC = GND, the switching frequency is 1.1MHz, and when SYNC = FLOAT, the switching frequency is 1.45MHz. In addition, applying an external TTL clock of 800kHz "2MHz to the SYNC pin can synchronize the amplifier with the system clock (provide a fully synchronized system) or distribute the spectral content of the switching harmonics to insensitive frequency bands. The amplifier when SYNC = VDD Working in SSM mode, in SSM mode, the switching frequency changes randomly around the center frequency (1.22MHz)? 20kHz. The modulation scheme does not change, but the frequency of the sawtooth wave changes with the period, and the energy is dispersed to the entire frequency that increases with the frequency Wide, instead of concentrating a large amount of spectral energy at the doubling frequency of the switching frequency. In the frequency band higher than a few MHz, EMI is equivalent to the white noise of the broadband spectrum. Compared with the traditional scheme, the spread spectrum mode improves the radiation index 5dB.
Filterless modulation
The MAX9700 / MAX9712 use a unique modulation scheme, which can eliminate the LC filter required by traditional Class D amplifiers, which not only improves efficiency, reduces the number of components, but also saves board space and system cost. When there is no signal at the input of the MAX9700 / MAX9712, the output switching waveform is shown in Figure 1. Since the amplifier drives the speaker in a differential manner, the two outputs cancel each other, so the net voltage in idle mode at both ends of the speaker is 0, reducing power consumption. In addition, because the output frequency of the MAX9712 is far beyond the bandwidth of most speakers, the offset of the audio coil caused by the switching frequency is very small. The square wave can be removed from the square wave using the inductance of the speaker coil and the natural filtering effect of the speaker and the human ear Audio components are restored in the output. For best results, an inductor greater than 10mH can also be used in series with the speaker.
Efficiency problem
The efficiency of Class D amplifiers is determined by the operating time of the output stage transistors. In a class D amplifier, the output transistor is like a current adjustment switch, and the extra power consumed is negligible. Any power loss related to the class D output stage is mainly caused by the MOSFET on-resistance and the quiescent current consumption.
SAMSUNG Controller Board Card, in stock.
Panasonic Sensor
Juki Sensor
Juki Laser Sensor
Juki Smt Sensor
Laser Sensor
Juki Cylinder
Juki Square Cylinder
Juki Air Cylinder
Cylinder Square
Square Cylinder
Fuji Cylinder
Fuji Sensor
Smt Cylinder
Air Cylinder
SAMSUNG PICK AND PLACE MACHINE SPARE PARTS J4901008A CD05-900004 CPU[INTEL CELERON733Mhz]
SAMSUNG PICK AND PLACE MACHINE SPARE PARTS J4901013A CD05-900007 CPU[PENTIUM IV 3.2C GHz(800MHz) 512 Cach
SAMSUNG PICK AND PLACE MACHINE SPARE PARTS J4901014A CD05-900008 CPU[INTEL CELERON 1.2GHz]
SAMSUNG PICK AND PLACE MACHINE SPARE PARTS J4901015A CD05-900009 CPU[PENTIUM IV 3.2E GHz(800MHz) 512 Cach
SAMSUNG PICK AND PLACE MACHINE SPARE PARTS J49011004A CD05-900010 CPU PENTIUM(D)-945
SAMSUNG PICK AND PLACE MACHINE SPARE PARTS J49011005A CD05-900040 RAM DDR2-512
SAMSUNG PICK AND PLACE MACHINE SPARE PARTS J49011006A
Controller Driver Boards Card,Samsung Controller Board Card,Samsung Control Pcb Board,Samsung Controller Driver Boards
Shenzhen Srisung Technology Co.,Limited , https://www.sr-smt.com