The electronic drain valve is matched with the solenoid valve by the analog circuit solid-state electronic timer to realize the automatic discharge of the condensed water of the compressed air system. High-pressure electronic drain valves are widely used in compressed air system components such as filters, separators, dryers, gas storage tanks, drip feet, etc. The discharge time and interval can be adjusted according to different needs.
characteristic
â—Imported IC chip, high quality, low price
â— One model is suitable for all applications, easy to install, fully automatic, maintenance free
â— Interval and discharge time are adjustable and have test buttons
â— Pressure 16Bar multiple voltages, multiple interfaces to choose from
â—All stainless steel valves and explosion-proof valves are available
â— CE certification, protection class IP65, insulation class H
â—Fluorine rubber seal
â—With 16Bar ball valve filter, separate from the drain valve, in an L-shaped structure
installation
First, before installing the drain valve, it is preferred to remove sludge, copper scrap, rust, etc. from the compressed air system. It is recommended to drain the system for 3-5 minutes under full pressure before installing the drain valve.
2. The direction of drainage is the same as the direction of the arrow on the valve body.
The three supply voltage should be consistent with the drain valve voltage (the drain valve voltage is marked on the coil). Do not connect the wrong power supply.
The TEST membrane switch on the four timers is a manual test button. Each time the button is pressed, the drain valve is discharged once. This button is used to check the drainage condition at any time in daily work.
The two knobs of the five timers are used to adjust the discharge and interval time. The user should adjust the time according to the climate and working conditions.
In addition to the connection function, the small screws on the six-drain valve junction box have the function of pressing the sealing gasket to prevent water from entering the timer and the coil, so it must be tightened. Otherwise, the gasket will not be waterproof, which will cause the coil and The timer is burnt out. The lock nut of the terminal is also waterproof, so be sure to tighten.
When the seven electronic drain valve is in use, there may be a situation where the solenoid valve is not tightly closed, which is always leaking. Usually the fault is not caused by the quality of the drain valve itself. The reason is that the condensate is too dirty, and the tiny solid particles enter it. The spool, the spool is stuck.
Anti-Jamming RC Arc Extinguisher
Anti-Jamming RC Arc Extinguisher
Anti-Jamming RC Arc Extinguisher
YANGZHOU POSITIONING TECH CO., LTD. , https://www.cnchipmicro.com