Do you know how to fill in the default gateway? With the rapid development of society, we will encounter various problems in our daily life. Let's take a look at how to fill in the default gateway.
How to fill in the default gatewayOpen the Control Panel, set the View Mode to Small Icon, then find and click on Internet Options.
Click "Change Adapter Settings" in the window that opens.
In the window that opens, right-click on "Local Area Connection" and select "Properties" from the pop-up menu.
In the "Local Area Connection Properties" window that opens, find "Internet Protocol Version (TCP/IPv4)" and double-click it to open it.
In the "Internet Protocol Version (TCP/IPv4) Properties" window that opens, check "Use the following IP address", then enter the IP address and subnet mask, enter the default gateway address in the default gateway input box, and finally click " Ok" complete the setup.
Test the gateway. Open the "Run" dialog and enter the command "CMD" to open the MSDOS window. Then enter the command "ping 192.168.1.1 -t" in the window. If the information shows that the data was successfully received, the default gateway configuration is successful.
When setting the IP address, there is a problem of filling in the default gateway. Of course, this should be filled in according to the actual situation of the user's network.
Use your mouse to click the wireless network icon at the bottom right of the taskbar → Open Network and Sharing Center
After opening the network connection, double-click the wireless network icon.
In the pop-up wireless status → General → Details
The default gateway data is impressive: 172.168.1.1
Why do many people's default gateways use 192.168.1.1? This is because the commonly used network access devices are all this IP address. Such as telecommunications broadband.
Because the router is used, the IP address of the default setting interface is also 192.168.1.1, which conflicts with the IP address of the front end. Therefore, the LAN port of the router is changed to 172.168.1.1, and the default gateway address is changed.
Open Network and Sharing Center → View Full Map
Later, the network mapping diagram will be detected and loaded.
Here you can see a schematic diagram of whether the network is unblocked (interrupts will have a big cross, click to call the wizard to fix). Computer→Gateway→Internet Network
As for the device, what is the question mark, mainly depends on whether there are other devices in the middle of the network connection? This is a power cat device (the system is unaware, so a question mark device icon is given).
Similarly, you can view the NMS data by using the command.
Start → Run → Enter: CMD Click OK (or press Enter) to open a command prompt window.
Then enter (or copy, paste) the command: ipconfig /all Enter to execute.
Wireless network→default gateway: 172.168.1.1
Note: The gateway in the router may not be the same as the default gateway in the computer (change the LANIP address). The specific situation needs specific analysis.
OKK Disposable Vape, OKK Disposable E-Cigarette
Shenzhen Uscool Technology Co., Ltd , https://www.uscoolvape.com