Wireless intelligent dimmer switch function parameter description

The wireless intelligent dimmer switch cooperates with the smart home control device to realize the wireless remote control and intelligent control of the common electrical appliances, bringing great convenience to people's lives.

1. Features

(1) small size, easy installation, can directly replace the ordinary switch panel.

(2) To achieve dual control, can be wirelessly controlled by partition walls, and can also be controlled using buttons on the panel.

(3) After the power failure, the caller is in a closed state to avoid unnecessary waste of electrical energy.

(4) There are one-way and two-way panels, which can connect one way and two way respectively.

(5) Applicable to family homes, hotels and other places.

(6) Applicable to various lamps (incandescent lamps, spotlights), various fans (ventilation fans, exhaust fans), etc.

(7) It has a brightness function that remembers the last time it was turned on, and avoids adjusting the brightness several times when it is turned on.

2. Working parameters

Unit load power: 500W/circuit; Operating voltage: AC220V/50Hz.

3. Installation

N: .220V zero line; L: 220 fire line; LD1, LD2 are the fire lines of the two lamps respectively; the zero line of the two lamps needs to be connected with the N220V zero line.

4. Switch function

(1) Registration mode. Turn the function switch to "SET" and enter the registration mode.

(2) Relay function. Set the function switch to "relay" block, which is the device with relay function in this system.

(3) Normal work. Turn the function switch to "normal" and the device is operating in normal mode.

5. Commissioning steps

(1) Registration system identification code and unit code

1 Enter registration mode. Set the function switch to "SET".

2 Register the system identification code. Press any unit button, the corresponding indicator light flashes immediately, indicating that the device has entered the setting state, use the main control device (smart handheld controller or central control host) to register the system identification code operation, after the successful registration, the light will stop flashing.

8 Register the unit code. Press the button corresponding to the unit to be configured, and the corresponding indicator light will flash immediately, indicating that the device has entered the setting state. Use the main control device (smart handheld controller or central control host) to register the unit code. After successful registration, the indicator will stop blinking. This step is repeated until all units of the device are registered with different cell codes on the same floor.

(2) Complete registration: Turn the function switch to “normal” position.

(3) According to the actual needs of the system, if the device needs to open the relay function, the function switch can be dialed to the relay block (only one device with relay function can exist in the same system).

(4) Whether the test equipment is controlled by the smart handheld controller or the central control unit wireless operation, whether the main control equipment can display the status change of the equipment.

(5) Operate directly on the panel's panel button to test whether it can work normally and reflect the status information on the main control device.

6. Use operation

(1) Button operation. In the normal mode and the relay mode, pressing the button on the panel can switch the switch status of the lamp (the corresponding indicator light on the panel indicates that the lamp is on, otherwise it is off). When the brightness of the dimming lamp is less than 50% when the lamp was turned off last time, the lamp is turned on at 50% brightness this time.

(2) Dimming operation. Press and hold the panel button, the brightness of the lamp will be adjusted brightly to the brightest and then gradually darkened. If the brightness is adjusted to the ideal brightness, release the button. When the brightness is adjusted, the corresponding lamp flashes. Wireless operation: Refer to the operating instructions of the system master control device for specific operations. When the lamp is turned on, the corresponding indicator on the panel goes out; when the lamp is turned off, the corresponding indicator on the panel is on.